Arteco Freecor EV Micro 10: recommended ultrapure rinse-water conductivity before refill
<5 µS/cmrecommendation
| Value kind | recommendation — Recommendations are design guidance, not measured facts; validate them against the project boundary conditions. |
|---|---|
| Scope | The fuel-cell-coolant leaflet recommends rinsing with the product or ultrapure water below 5 µS/cm, then draining fully. This is a named-product instruction; use in a data-center loop requires the approved fluid and equipment compatibility basis. |
| Caveat | Not a generic DLC flush or acceptance limit. Other fluids and equipment require their own approved compatibility, cleanliness, chemistry, and documentation criteria. |
| As of | 2026-03 |
| Source | Arteco, Freecor EV Micro 10 Product Information Leaflet, version 202603-v02.1, March 2026. · Page 4, Handling instructions |
| Derivation | Manufacturer handling recommendation for the named formulation; its rinse-water threshold does not establish a universal DLC acceptance criterion. |
| Review | checking…review by 2027-03-08 · standard cadence |
| Recorded changes | last 2026-09-16 · 2 revisions tracked |
| Claim id | secondary-loop-conductivity-ceiling-flushed-to |
Where the guide uses it
← Full numbers register — every date-stamped figure in the guide, with revision history.